The BPU is typically mounted in a covered area outside of the operator’s cab near the battery. It is important to make sure it is kept away from extreme heat.

Ultimately, the final installation location will be dictated by the maximum cable length available for the sensors and the antenna.

• The BPU may be installed in any orientation, however the cable harness must be supported to relieve radial tension of the M12 panel connectors.

• If the BPU is mounted vertically, it is recommended to install with the connector panel facing downwards to prevent water pooling at the connectors.

Mounting locations

• The BPU has four M8 mounting tabs at each corner.

• A magnetic mounting kit is provided as well as an M8 fastening kit.

• It is important to consider potential theft when choosing a mounting location.

• Holes must not be drilled into any structural or safety items such as Roll Over Protection Structures without manufacturer approval.

Open

BPU with switch and power block mounted to the roof of a telehandler

Open

BPU bolted inside the cab of a wheel loader behind the operator’s seat

Open

BPU bolted on the rear of the cab on a telehandler

Open

BPU installed on a forklift using magnets to the counter-weight. A service panel hides the system during normal works